1U BTX Low Cost Rackmount Server, CM72 Pentium D 2.8 Ghz Model

Product Information

CM72 1U BTX Dual Core 2.8Ghz Processor, Single Pack

$965.00

System Configuration
Model	CM72
Motherboard	Integrated Intel® D945GCZ microBTX motherboard
Processor	Intel Pentium® 4 D Dual Core processor 820 2.8 Ghz Processor, 800 Mhz FSB, 2MB L2 Cache, EM64T
Chipset	Intel 945G Chipset
Processor Socket	LGA775
PCI-Express Slot	Available one 16X PCI-Express slot (PCI-Express Riser card not included)
PCI Slot	Not supported
System memory	1GB of 400Mhz DDR2 SDRAM (PC2-3200), supports up to 4GB
Audio Ports	2 x Enhanced Bus Master IDE ports ( supports up to 4 IDE Drives ) Ultra DMA 100/66 (chassis support up to two hard drives)
Ports	1 x DB9 Serial port, 1 x Parallel port, 2 x USB 2.0 ports, 1 x PS/2 Mouse port, 1 x PS2/2 Keyboard port, and three analog 6-channel audio ports.
Network Support	Intel 10/100 Mbit/sec Lan subsystem using the Intel 82562GX/82562GZ platform Lan connect (RJ45)
BIOS	Intel BIOS
Floppy Drive	Not Installed (Optional)
Video Support	Build onboard Intel GMA 950 graphic subsystem
CD-ROM Drive	BenQ or Sony 52X CD-ROM Reader (IDE) Color: Black
Hard Disk	Samsung or Seagate 120GB SATA-150 IDE Hard Drive 7200 RPM 8MB Cache
Software	No Operating system installed. ( Comes with windows device driver CD)
Power Supply	ATX 400 watts power supply (Dual 110v/220v Auto-sensing switch)
Power consumption	Between 100 watts to 125 watts with standard configuration
Rack Support	Support 2 or 4 post rack, relay rack. Requires the rear mount bracket kit. (Not included)
Warranty	One-year limited warranty. ( Parts & Labor) Purchase the ColoMachine Extended Warranty Plan to extend your service and support up to two additional years.


Specifications

Processor Pentium D 2.8 Ghz Processor 2MB on-chip L2 cache 800 Mhz Front Side Bus (FSB) EM64T Memory Four 240-pin DDR2 DRAM DIMM Sockets Support for DDR2 667, DDR2, 533, or DDR2 400 Mhz Non-ECC DIMM Support for up to 4GB of system memory Supports Dual channel (Interleaved) Mode System Chipset Intel 82945G Graphics Memory Controller Hub (GMCH) Intel 82801G I/O Controller HuB (ICH7) Peripheral Interfaces Eight USB 2.0 ports. Supports UHCI and EHCI. (2 USB ports accessable from front.) One Serial port. Supports up to 115.2Kbits/sec One parallel port Four Serial ATA interfaces On parallel ATA IDE interface with UDMA 33, ATA-66/100 support One diskette drive interface PS2/ keyboard and mouse ports Storage Seagate or Samsung 120GB SATA-150 IDE hard Drive 7200 RPM 8MB Cache Sony or BenQ 52X IDE CD-ROM Reader. Color: Black Storage Bay Two 3.5" removable hard drive bay. One is used by the seagate 120GB SATA hard drive and other one is available. One 5.25" CD-ROM bay.	Video Intel GMA 950 onboard graphics subsystem 400 Mhz core frequency Integrated 24-bit 400 Mhz RAMDAC Up to 2048 x 1536 at 75 Hz refresh Dynamic Video Memory Technology (DVMT) support up to 224 MB LAN 10/100 Mbit/sec LAN subsystem using the Intel 82562GX/82562GZ platform lan connect device Audio 6-channel (5.1) audio subsystem with three analog audio output using the Sigmatel 9220 audio code Microphone input that supports a single dynamic, condenser, or electret microphone Expansion Capabilities One PCI Express x16 bus add-in card connector Support PCI Express Revision 1.0a Up to 8GBytes/sec transfer speed Environmental Requirement Maximum continuous power : 400 W Line voltage : 100-240V AC Frequency: 50Mhz to 60Hz, single phase Operating temperature: 0 to 35 C Storage temperature :-40 to 70 C Relative humidity : 5% to 95% noncondensing Maximum altitude: N/A Size and Weight Height: 1.75" (1U Rackspace) Width: 19" Depth: Weight: 37 Lb

Quick Link >>